ICSIronmark Critical Services

Service / FA-01

Fire alarm engineering

Planned maintenance, fault investigation, commissioning and recovery for commercial fire detection and alarm systems.

Discuss this requirement
SCOPELIFE SAFETY / DETECTIONICS / FA-01

The work

Fire alarm fault finding, PPM and commissioning.

The device named on the panel is not always the source of the fault. The investigation may also need to cover cabling, power supplies, network communications, interfaces, configuration and site conditions.

PPM visits cover the agreed inspection and test schedule, system condition, fault history and defects requiring further work.

Approach

From the reported fault to a tested conclusion.

The exact test plan depends on the system, its condition and the effect of taking equipment out of service. These are the usual stages for this type of work.

01

Establish the fault pattern

Review event logs, previous attendance, panel indications and when the issue occurs.

02

Trace the signal path

Test the device, circuit, loop, panel, network and interfaces that can produce the reported condition.

03

Prove the outcome

Retest the affected operation, record remaining defects and define any remedial work.

What ICS can investigate

Check the complete operating sequence.

  • +Control equipment, loops and field devices
  • +Networked panels and communication paths
  • +Power supplies, batteries and cable integrity
  • +Cause-and-effect logic and third-party interfaces
  • +Fault history, configuration and available records

Outputs

Test results, findings and required work.

The report format and level of detail are agreed before the work starts.

Useful before attendance

  • Panel make, model and network arrangement
  • Zone chart and cause-and-effect information
  • Recent event logs and maintenance reports
  • Known access or isolation constraints

PPM service record

Technical findings report

Test and observation records

Prioritised defects and recommendations

Cause-and-effect verification evidence

Defined recovery or remedial scope

Contact ICS

Have the fault history and system records ready.

Discuss the work